The transceiver is controlled by six buttons plus two buttons on the encoder settings and volume which are located on the front. Transmission tone for tuning the antenna tuner, amplifier. Selection of the signal display spectrum or waterfall. Indication of the received signal level (S-Meter) from S1 to + 60dB. The ability to control the transceiver via CAT protocol (Kenwood TS-440) via USB port. (10-100).Įnable sound confirmation of pressing the control buttons. Three AGC modes: Fast, Medium, Slow, Disabled.Īdjust the brightness of the display. with a step of 100 Hz.Īudio input selection mode, microphone or linear.Īdjust the sensitivity of the microphone and line input. Receiver detuning with transmitter (CW SHIFT) 0–1500 Hz. The mode of switching on the transmission by pressing the telegraph key (auto transmission).Īdjustable delay to receive (when CW auto transmission is on)Īdjusting the speed of the electronic key.
#Miniradio by somhein manual
Manual and electronic telegraph key (Straight Key, Jambic key or Single Paddle Key). Operating modes: LSB, USB, CW, AM (reception only), DIGI. Settings for the lower and upper cutoffs are 50-300, 2500-3200 Hz.) (Separate slice settings from the bottom and top) LSB / USB Mode: Set from the menu and has three fast access presets (HP 40-400, LP 1500–3500 GC.). (Zoom x1).ĭepending on the ambient temperature, the temperature of the transceiver housing and the accuracy of the instruments, a frequency instability of 5-35Hz is possible.ĬW Mode: Set from the menu and has two quick access presets (SHIFT 600–1000 Hz. The spectrum display band on the display is 14 kHz. The input output impedance of the antenna input is 50 ohms.
The output power of the low frequency amplifier: >0.5w. At 100% volume: up to 200mA.Ĭurrent consumption in “TX” transmission mode: 600-1600 ma. Supply voltage: 8-15v (Rated supply voltage 13.8v)Ĭurrent consumption in receive mode “RX” and 25% volume: 120mA. It is suitable for work on the field trip, on the nature, cottage. The transceiver has small dimensions 100x103x30 mm. Onboard the transceiver there is a USB port for connecting to a computer to control the transceiver from amateur radio programs using CAT protocol “Kenwood TS-440” ) as well as the reception of radio stations with AM modulation. It is possible to work in digital forms of communication "DIGI" (JT / PSK / BPSK / FSQ and all others. This transceiver is designed to work in the lower (LSB) and upper (USB) sideband with both a telephone (SSB) and a telegraph (CW). SSB SDR transceiver is a shortwave, ten band, multi band.
0 kommentar(er)
